Copper Fermentation Tank
If you are would like to change, add, remove or modify any part of the tanks, we can accommodate that. Specific fitting sizes, changes and locations will be set during the design process after a deposit is taken.
Fermenter Configuration:
1. 4 stainless steel legs with leveling footpads
2. Interior shell: 304 stainless steel, thickness 3mm
3. Exterior shell: 304 stainless steel, thickness 2mm
4. Interior and exterior finish bright polish to 0.6~0.8, hygiene surface
5. 60 degree cone bottom, other angles can be specified during the design process
6. Combined drain extensions and beer port in cone are standard
7. 25% headspace, unless a different volume is requested
8. Top manway or side manway door
9. Dual zone in sidewall and cone dimple cooling jacket with glycol inlet and outlet
10. Polyurethane insulation thickness 80mm for cooling jacket on side and bottom
11. Fully welded exterior shell
12. Non welding CIP arm and rotating 360 degree reach spray ball
13. Solenoid relief valve, pressure relief valve (safe valve) are standard
14. Pressure gauge
15. Temperature sensor well
16. Sanitary sample valve and port
17. All clamps and gaskets to attach all accessories
18. Tank complete with piping, fittings, sanitary valves and all parts.
19. Carbonation port is available for special request (stone not included)
20. Ladder hooks is available for special request
21. Dry hop ports and/or hop bag hooks in any fermenter of any size for special request.
